Solve the Problems during Using Vibrating Screen

RELEASE TIME:2017-09-22 10:13:55

Vibrating screen is not a large equipment, but the vibration sieve failure frequency is the highest, because the vibration device itself is a kind of vibration of the destructive force of a scientific use of a product.

when the motor turns wrong, according to the electronic control box to stop the button, then the vibrating screen will slowly stop, to observe the side of the small points in the vibrating screen when the formation of the elliptical trajectory to correct rotation. Secondly, remove the vibrator shroud, check apricot eccentric block whether the rotation to the outside; Thirdly, exchange control box into the line power of any two phase line, in the sieve above the sand some sand, one is the right direction.

The accumulation of clay is too small, Screen and screen frame is not tightly supporting the screen. The way to solve the problems is to increase the vibration amplitude, then spray the water with the screen and cuttings to reduce the sticks of the sticky, but this method is only suitable for allowing the occasion to add water; third, adjust the sand mouth of the screen angle down; last, replace the screen mesh or adjust the flow of a single screen to ensure that the flow of fluid near the screen outlet, so that cuttings in the drilling fluid lubrication under the smooth discharge.