The preferred jaw crusher for crushing of large pieces of limestone

RELEASE TIME:2015-12-09 12:01:40

  Jaw crusher is commonly used in mine, because its maximum compressive strength is not more than 300MPA, so it is generally used to break the texture of soft stone, such as limestone crushing can be completely broken, in the limestone crushing production line, jaw crusher is characterized by the following:

 1, Jaw crusher, the largest broken particle size of 1000*1200mm, can be completed in the large block of limestone.

2, Jaw crusher can effectively solve the problem of the high output of limestone crushing due to low operating rate, no maintenance time.

3, Jaw crusher in crushing 1 tons of limestone power consumption by 1-2KWh\/t, the annual electricity can save a lot of money.

4, The mixture of the two kinds of materials is good, and the addition of limestone is greatly improved. Dosage can reach 60%, effectively reducing the cost of raw materials.

5, The scrap size is small, only 2-15mm can effectively solve the original limestone granularity, often blocking even affect the output of mill chute problem.

 In addition, the jaw crusher is small, the structure is simple, the crushing granularity is big, the product particle size is very suitable for the large material. Although the limestone storage capacity is relatively large, but in recent years, a large number of projects caused by the scarcity of limestone. The emergence of jaw crusher can solve this problem, which can not effectively break the large limestone, and greatly improve the production of limestone.