Ways to Solve the Problem of Sand Making Machine

RELEASE TIME:2017-08-16 16:30:22

Sand making machine for soft or medium hard and very hard materials broken, plastic, widely used in a variety of ore, cement, refractory materials, aluminum earth clinker, emery, glass raw materials, construction sand, stone and various metallurgy Slag, especially for silicon carbide, emery, sintered bauxite, sand and other high hard, special hard and abrasive materials than other types of crusher production efficiency is higher.

Sand machine in the production process, there is a certain body swing, but the amplitude is not large, if the body swing particularly violent, then there may be three reasons:

(1) may be crusher impeller wear on the wear comparison serious. If the impeller on the wear parts of the wear and tear will cause a serious sand machine internal operation is not smooth, resulting in swing too much, this time as long as more pieces of easy parts, so that the sand inside the impeller to balance the state;

(2) May be too large material caused by the equipment swing too large, sand making machine in the design of the equipment, the maximum feed size is generally 4 to 5 cm, in general, the equipment feed grain size in the 3 to 4 cm when finished The amount of sand can be achieved up to the maximum, if the feed caused by the equipment swing too large, if the feed is too small, the collision is not fully broken enough to reach the full amount of finished sand;

(3) sand making machine may also be impeller Obstruction, if the impeller flow channel obstruction, then it will cause uneven feeding, the body swing too large, as long as the impeller on the channel out of the obstruction can solve the problem of excessive body swing.