The ways to reduce the cost of jaw crusher

RELEASE TIME:2017-06-09 10:27:09

 Jaw crusher is mainly used to break the material, and most of the material is ore and the similar, Zhongxin often deal with these ores, wearing parts of the wear and tear is normal, and the general crusher is working outdoors , The working environmentwhich compares to others‘ is more  poor, these series of problems  will cause a certain impact for the life of the crusher, so  do a good job of crusher maintenance work, daily regular maintenance and repair can extend the life of the crushe. In order to timely identify problems to solve the problem, so as not to affect the normal work.

The working environment of the jaw crusher seriously affects the service life of the crusher, especially for jaw crushers such as the equipment for the rough, by the wear even greater, and frequent maintenance of the replacement parts for the business Said it would increase the cost of investment, which is the concern of people. Then how to do to reduce maintenance costs? Take jaw crusher for it, jaw crusher thrust plate is made of cast iron material, thrust plate is cast steel or variant cast iron pieces.Thrust plate plays not only the role of movement and force, but also in security and adjustmentof  the size of the discharge. As the thrust plate installed in the lower part of the body,it is not  easy to maintain, so the board and the board is the most easy to wear parts, after wearing and tearing  the board, we can use efficiently after surfacing processing, spraying, brush plating and other methods of repairing. When the thrust plate is broken, due to functional role, generally no longer repair, should replace the new thrust plate. But the combination of thrust plate, removable plate head to continue to use.

 At the same time, we have to do the maintenance of broken equipment, often check the various parts of the crusher wear and tear, timely maintenance can extend the service life of equipment, saving equipment investment. In addition, the vibration of the crusher is very large, long-term work when the fretting wear, the screw slider, screw hole grinding, through-hole wear, such as the ground bolt hole, bearing screw, spring rod rack support Wait. After these holes are worn, the bolt through holes may be welded to the plate or to increase the diameter of the screw.