1, before the start of the inspection
① to carefully check whether the loose fasteners, wear parts need to be replaced, the safety cover is complete.
② According to the physical properties of materials and the requirements of the grain size, adjust the strike board and the gap between the counterattack plate. If there is special need to change the rotor speed.
③ Check the lubrication system, cooling system is easy to use.
2, open, shutdown and operation of the Notes
① start-up sequence: dust collection equipment → transport equipment → impact crusher → feeder. The first empty operation, check to determine no abnormal phenomenon before feeding.
② to feed to be uniform, to prevent more than the provisions of the large fast feed, to prevent the metal block feed.
③ always check the lubrication system and cooling system work, and pay attention to the bearing and motor bearing temperature. If more than the specified value, should be promptly addressed.
④ regular attention to the size of the material is appropriate, such as more than the provisions of the scope should be promptly adjusted.
⑤ pay attention to the equipment closed and workshop dust collection work.
⑥ attention to whether the loose bolts on the body, such as loosening should be shut down for repair. Do not perform repairs during operation or open inspection door inspection.
⑦ stop, you should first stop the feeder, standby body material is broken after the end of motor, and then stop the delivery of equipment and dust collection equipment. And after the shutdown should be promptly check the fastening bolts, check the attack board, counterattack plate wear.
